Easy Step-By-Step Instructions | How to Mount a Self Mount
IMPORTANT : NEW VENTURA ADHESIVE
• The new Ventura adhesive allows for initial print repositioning.
• Once the print has been pressed on to the page, the adhesive will activate and start setting.
• Removing or repositioning the print, at this point, will diminish the effectiveness of the adhesive.
BASIC ASSEMBLY INSTRUCTIONS – working only one page at a time
|Step 1 :||Expose a small area of page adhesive at the upper corner of the page.|
|Step 2 :||Carefully position the print on to the adhesive.|
|Step 3 :||Expose the rest of the adhesive and carefully press the print down while brushing all air pockets from beneath the print.|
DETAILED ASSEMBLY INSTRUCTIONS – working only one page at a time
|Step 1 :||Slightly peel back the contact tape at the top of the page. This will expose the top portion of the page adhesive to allow for print positioning.|
|Step 2 :||Carefully position the print on to the page by holding the top corners of the print and aligning it to the page.|
|IMPORTANT : You may reposition the print at this time. Be careful not to press down on the print as this will activate the glue.|
|Step 3 :||Once the print is in position, apply pressure to the top edge of the print where it is contacting the page adhesive. This will activate the adhesive and set the photo to the page.|
|WARNING : Do not remove the print once it has been pressed on to the page. Doing so will dramatically diminish the glue’s effectiveness.|
|Step 4 :||Once you have set the photo to the page, gently lift up the bottom portion of the print and remove the remaining contact tape.|
|Step 5 :||From top to bottom, slowly lay the remaining portion of the print on to the adhesive all the while smoothing the photo to remove any air pockets.|
|Step 6 :||Finally, apply pressure to the entire print to fully adhere the print to the page.|